Advertisement
Quick Links
Operation Manual
Spreader 30 kg
50133, 50143
Illustration similar, may vary depending on model
Please read and follow the operating instructions and safety information prior to initial operation.
Technical changes reserved!
Illustrations, functional steps and technical data may deviate insignificantly due to continuous further
developments.
Advertisement
Related Manuals for WilTec 50133
Summary of Contents for WilTec 50133
- Page 1 Operation Manual Spreader 30 kg 50133, 50143 Illustration similar, may vary depending on model Please read and follow the operating instructions and safety information prior to initial operation. Technical changes reserved! Illustrations, functional steps and technical data may deviate insignificantly due to continuous further...
- Page 2 The information contained in this document may alter at any time without prior notice. No part of this document may be copied or otherwise duplicated without prior written consent. All rights reserved. WilTec Wildanger Technik GmbH cannot be held liable for any possible mistakes in this operating man- ual, nor in the diagrams and illustrations shown.
- Page 3 Only use the spreader in walking pace. Never run with the spreader. • Do not use the spreader in rain or strong wind. Never leave it out in the rain. © by WilTec Wildanger Technik GmbH Item 50133–50143 Page 3 http://www.WilTec.de...
- Page 4 Step 1 Put the plastic bearing of the axle into the opening of the frame. Then introduce the axle. Step 2 Put the tyre and its rim onto the axle. © by WilTec Wildanger Technik GmbH Item 50133–50143 Page 4 http://www.WilTec.de http://www.aoyue.eu...
- Page 5 Put the opposite part of the tyre onto the axle. Step 5 Insert a cotter into the outer hole of the axle and bend it to fix the tyre on the axle. © by WilTec Wildanger Technik GmbH Item 50133–50143 Page 5 http://www.WilTec.de...
- Page 6 After performing the above steps, the basic frame of the spreader should be as depicted. Now insert the cross-tie depicted into the frame and screw it to both frame parts. Step 7 Now mount the handles and additional cross-ties. © by WilTec Wildanger Technik GmbH Item 50133–50143 Page 6 http://www.WilTec.de http://www.aoyue.eu...
- Page 7 Pre-mount the handle parts (see fig.) to be able to mount the handles. Step 9 Screw the handles to the frame. Screw the additional cross-ties to the frame to reinforce the handles. © by WilTec Wildanger Technik GmbH Item 50133–50143 Page 7 http://www.WilTec.de...
- Page 8 On the points depicted, insert the screws through the hopper. Tighten them to fix the hopper to the frame. Insert a cotter through the spindle of the drive unit in the middle part of the hopper. This will serve as a blunger spreading the grit. © by WilTec Wildanger Technik GmbH Item 50133–50143 Page 8 http://www.WilTec.de...
- Page 9 Picture of the hopper mounted Step 12 The manual pull that one can adjust the opening width with is connected to the left handle with the help of a screw. © by WilTec Wildanger Technik GmbH Item 50133–50143 Page 9 http://www.WilTec.de http://www.aoyue.eu...
- Page 10 Important Note: Reproduction and any commercial use (of parts) of this operating manual, requires a written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 50133–50143 Page 10 http://www.WilTec.de http://www.aoyue.eu...