Screen Settings - Sony FWD-S42H1 Operating Instructions Manual

Screen Settings

For Video Input
PAP Setting
Available combination of two pictures
S Video
Video
RGB
RGB/YUV
Component
DVI
1) Supported when "Display" is set to "YUV" or when "Option" is set to "RGB" in "RGB/YUV".
2) Supported when "Display" is set to "RGB" or when "Option" is set to "YUV" in "RGB/YUV".
Tip
Output from BKM-FW50 is considered as RGB output shown in the table in the "PAP" mode.
26
GB
VIDEO
Allows you to show two pictures from different signal sources, such as a PC and a
video, side by side.
"PAP"
"Off": Disables "PAP" function.
"P&P": Shows two pictures side by side at the same time.
"PinP": Displays two pictures as the inset picture within the main picture.
For P&P
"Active Picture": Selects the screen to operate.
"Left": You can activate the left picture to operate it.
"Right": You can activate the right picture to operate it.
"Swap": Swaps the two pictures side by side.
"Picture Size": Adjusts the balance between two pictures side by side. Adjust the
balance by pressing G or g button, and then press
(page 16)
For PinP
"Active Picture": Selects the screen to operate.
"Main": You can activate the main picture to operate it.
"Sub": You can activate the inset picture to operate it.
"Swap": Swaps the main and the inset pictures.
"Picture Size": Adjusts the size of the inset picture. Select from "Large" or "Small".
"Picture Position": Adjusts the position of the inset picture with F/f/G/g, then
press .
Tip
You cannot change the aspect ratio in the "PAP" mode. The picture is displayed in the last
aspect ratio used prior to selecting "PAP" mode.
RGB/YUV
S Video Video
RGB
a
a
a a
a a
a a a
To highlight an option and to change settings, press
F f G g
/ / / .
Press to confirm the selection.
The "Screen" settings include the following options:
DVI
Component RGB
a a a
a a a
a
a a
a a
button to set the adjustment.
OPTION
Component HDMI
a a
a a
2)
a a
1)
a
a
HD-SDI/
SDI
a
a
a
a