Sony FWD-S42H1 Operating Instructions Manual page 60

Note
You cannot use the HDMI button and the OPTION 2 button on this display.
14
GB
9 ID MODE (ON/0-9/SET/C/OFF) buttons
You can operate a specific display without affecting other displays
installed at the same time.
• ON button:
Press to show the "Index Number" on the screen.
• 0-9 button:
Press to enter the "Index Number" of the display you want
to operate.
• SET button:
Press to set the input "Index Number".
• C button:
Press to clear the input "Index Number".
• OFF button: Press to return to the normal mode.
See page 17.
+/– button
0
Adjusts the picture (contrast) level.
+/– button
qa
Press to adjust the volume.
button
qs
Press to mute the sound. Press again to restore sound.
button
qd
Selects the "PAP" (Picture And Picture) mode. Each press toggles
between "P&P", "PinP" and the single-screen picture. See page 16.
qf DISPLAY button
Press to display the currently selected input, the type of the input
signal and the "Aspect" setting on the screen. Press again to hide
them. If this displayed information is left undisturbed for a short time,
it will disappear automatically.
qg OPTION 1 button
When an optional adaptor is installed, selects an input signal from the
equipment connected to the optional adaptor.
If the installed optional adaptor has multiple input connectors, each
press of the button toggles between the input signals.
qh HD15 button
Press to select the input signal of the HD15 (RGB/COMPONENT)
connector. The RGB signal or component signal is selected
automatically or manually in accordance with the menu settings.
qj STANDBY button
Press to change the display to the standby mode.