Acura 2009 RL Owner's Manual page 218

Main Menu Table Of Contents
STEREO ICON
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Press the AUDIO button to
view the audio control display. Turn
the system on by pressing the
power/volume knob or the AM/FM
button (AM or FM button on
Canadian and Hawaiian models).
Adjust the volume by turning the
power/volume knob.
The band and frequency that the
radio was last tuned to are shown on
BAND
the display. To change bands, press
the AM/FM button (AM or FM
button Hawaiian models). You can
also change bands between FM1 and
FM2 by pushing the interface
selector up. Each time you push it up,
the band will change to FM1 or FM2.
On the FM bands, STEREO will be
shown on the navigation screen and
ST on the upper display, if the
station is broadcasting in stereo.
Stereo reproduction on AM is not
available.
To Select a Station
You can use any of five methods to
find radio stations on the selected
band:
TUNE, SEEK, SCAN,
preset buttons, and
the
AUTO SELECT .
2009 RL
Audio System
TUNE ICON
Use the TUNE bar to tune
TUNE −
the radio to a desired frequency.
Press the right side of the bar to
tune to a higher frequency, or the
left side to tune to a lower frequency.
To tune with the interface dial, push
the selector down, and turn the knob
to TUNE icon. Then press ENTER
on the selector, and turn the knob to
the desired frequency. To exit the
TUNE mode, press ENTER on the
selector, then push the selector up.
CONTINUED
215