Acura 2009 RL Owner's Manual page 180

Main Menu Table Of Contents
Also, if you close the door when the
ignition switch is not in the LOCK
(0) position and the remote is not
inside the vehicle, the keyless access
alarm sounds outside the vehicle, a
message appears on the multi-
information display, and the beeper
sounds if the ignition switch is in the
ON (II) position.
When the beeper sounds after you
close the driver's door outside the
vehicle, check the position of the
ignition switch and the location of
the remote.
If the engine is running and you
remove the remote from the vehicle,
it will continue to run. But once
turned to the LOCK (0) position, the
engine will not restart until a remote
is brought back into the vehicle.
Removing the Ignition Switch
Cover
IGNITION SWITCH COVER
BUILT-IN KEY
To remove the ignition switch cover,
insert the built-in key (see page
then pull the cover out by pulling the
built-in key while pushing it.
2009 RL
Keyless Access System
Beeper and Message
Keyless Remote Not Detected
pull
push
When you are pressing the ignition
180 ), switch, or when the ignition switch is
in the ON (II) position, the beeper
sounds if you take the remote out of
the vehicle and close the door.
CONTINUED
177