Sony FWD-42PV1A Operating Instructions Manual page 68

Using On-screen Menus
Remote
This menu is used for remote control settings.
Index Number
Sets the index number of the display.
Note
When you set the index number, use the buttons on
the display unit. The index number cannot be set with
the Remote Commander.
For details on the Index Number, see "Operating a Specific
Display With the Remote Commander" on page 44 (GB).
Control Mode
Selects the function of the Remote Commander.
Display + Remote: Activates a remote commander
supplied with the display.
Display Unit Only: Disables the remote control
function. You can only make settings for the
display using the control buttons on the display
unit.
Remote Only: Disables the controls on the display
unit when you want to control it using the Remote
Commander only. You can only make settings for
the display using the Remote Commander.
Note
When operating this item, the modes you can select
differ depending on the key you are using.
When using ENTER on the Remote Commander for
setting, you can select only "Display + Remote" or
"Remote Only."
When using ENTER on the display unit for setting,
you can select only "Display + Remote" or "Display
Unit Only."
20
(GB)
INITIAL SETUP/INFORMATION
menu
You can select the on-screen language or the input
signal, or display various information such as the
Operation Time.
INITIAL SETUP/INFORMATION
Language: English
Color System: Auto
Auto Shut Off: Off
Auto Screen Adjust: On
Information
IP Address Setup
Speed Setup
Select Set
ENTER
Language
Selects the on-screen language (Japanese, English,
German, French, Spanish, or Italian).
For details, see "Selecting the On-screen Language" on
page 37 (GB).
Color System
Selects the Color System of video signals.
Auto: to set the Color System automatically.
NTSC: to display NTSC signals
NTSC4.43: to display NTSC4.43 signals
PAL: to display PAL signals
SECAM: to display SECAM signals
PAL-M: to display PAL-M signals
PAL-N: to display PAL-N signals
PAL60: to display PAL60 signals
Auto Shut Off
When you set this item to "On," the display unit
automatically enters the standby mode when a signal
is not input to the COMPONENT or DVI input
connectors for more than about five minutes. The
display unit automatically enters the power saving
mode when a signal is not input to the DVI or RGB
input connectors for more than about thirty seconds.
While in the standby mode, press the 1POWER
switch on the display unit or the POWER ON button
on the Remote Commander to switch the display unit
on. While in the power saving mode, the display unit
is automatically turned on when a signal is input.
Exit
MENU