Dyna-Glo DGO1176BDC-D Quick Start Manual page 7

Charcoal offset vertical smoker

Hide thumbs Also See for DGO1176BDC-D:

ASSEMBLY INSTRUCTIONS

CAUTION: This unit is HEAVY! Do not attempt

this step without assistance!

With the assistance of a helper, stand the unit up

right on its legs on a firm and level surface. (Make

sure that legs are well attached). Place both doors

back onto the smoker body. Position the square

smoke stack (A) with control arm to the left as

shown. Using 4 bolts (AA), attach square smoke

stack (A) to the top of smoker body (G). Securely

tighten with a Phillips screwdriver.

Hardware Used

M6 x 12mm

Screw

Attach lifting handle (B) to smoker body-left (G)

using four M6x12 screws (AA).

Hardware Used

M6 x 12mm

Screw

Attach door handle bracket (K) to smoker

body-left (G) using two M6x12 screws (AA).

Hardware Used

M6 x 12mm

Screw

x 4

x 2

Table of Contents