End Of Season Storage; Beginning Of Season - IBEX TX31 Operator's Manual

5.4 End of Season Storage

After using the machine for the last time of the season, perform the following actions to prepare the
machine for storage after completion of daily maintenance procedures.
• Remove all covers and clean all parts of the machine of dirt and debris. Thoroughly clean the inside of
the pickup, the bale chamber, and other hard to reach areas where debris tends to accumulate.
Compressed air is recommended for hard-to-reach areas. Do not use water when cleaning near
bearings or grease fittings.
Perform a full inspection of the machine to check for any damaged components. Replace as needed.
•
• Check tire pressure and inflate as needed. Check tires for signs of wear.
• Lubricate the machine according to the Maintenance Schedule in Section 5.2.
Apply paint or grease to any bare metal surfaces to prevent rust.
•
Remove the 9V battery that powers the bale chamber full alarm horn.
•
• Store the machine in a well ventilated indoor space. If no indoor space is available, cover the machine
with a plastic tarp, removing it occasionally to allow accumulated moisture to dissipate.
• Inspect the machine occasionally for any accumulation of moisture, rust, or other problems and address
accordingly.

5.5 Beginning of Season

Before the first use of the season on a used machine, perform the following actions to ensure trouble-free
operation.
• Inspect the machine for any rust, animal nests, or other problems.
Clean the machine thoroughly of any dirt or debris that has accumulated in the off-season.
•
• Check tire pressure and inflate as needed. Check tires for signs of wear.
• Lubricate the machine according to the Maintenance Schedule in Section 5.2.
Apply paint or grease to any bare metal surfaces to prevent rust.
•
Install the 9V battery that powers the bale chamber full alarm horn. Check electrical wires for any signs
•
of wear. Replace as needed. Test horn function using the switch and replace battery as necessary.
• Connect the machine to the tractor as discussed in Section 3. Start the machine with the tractor at idle
engine speed. Check for any operating problems. Test tailgate cylinder function.
• Before attempting to bale for the first time, create a windrow of hay or straw from a small area of
field/stand and attempt to bale it. Address any and all problems before attempting to begin work.
20 Ibex TX31 Mini Round Baler with Net Wrap - Operator's Manual