Philips 32PFL5007D/30 Service Manual page 19

2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
4.4.6 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.4.7 Keyboard Control unit
1. Unplug the connector from the keyboard control panel.
2. Gently push inwards the two clips at the PSU side of the
unit. Release the unit at the PSU side and turn it away from
the PSU. Now push it towards the PSU to release the
catches at the other side of the unit. Take it out from the
metal bracket.
When defective, replace the whole unit.
4.4.8 IR/LED Panel
1. Unplug the connector from the IR/LED panel.
2. Gently release the clip that holds the panel and take it out
from the bezel.
When defective, replace the whole unit.
4.4.9 AmbiLight control panel
1. Unplug the connector from the AmbiLight control panel.
2. Gently release the clip that holds the panel and take it out
from the set.
When defective, replace the whole unit.
4.4.10 LCD Panel
1. Unplug the all the connector cables of the boards.
2. Lift the subframe with PSU, SSB, Keyboard control panel,
IR/LED board and AmbiLight control panel from the LCD
panel and put it aside.
3. Gently take all the speakers out.
Warning: Cause the panels of 6007 series are bolt-on panels
so the panel could not release from bezel.
When defective, replace the whole unit.
4.5 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
• While re-assembling, make sure that all cables are placed
and connected in their original position. See
Figure 4-7.
• Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.
Mechanical Instructions
Figure 4-4 and
back to
div. table
TPM9.5A LA 4. EN 19
2012-Nov-30