Philips 32PFL5007D/30 Service Manual page 15

4.3.3 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Gently unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
4.3.4 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.3.5 Keyboard Control unit
1. Unplug the connector from the keyboard control panel.
2. Gently push inwards the two clips at the PSU side of the
unit. Release the unit at the PSU side and turn it away from
the PSU. Now push it towards the PSU to release the
catches at the other side of the unit. Take it out from the
metal bracket.
When defective, replace the whole unit.
4.3.6 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
Mechanical Instructions
4.3.7 IR/LED Panel
1. Remove the stand bracket, as described earlier.
2. Unplug the connector from the IR/LED panel.
3. Gently release the clip that holds the panel and take it out
When defective, replace the whole unit.
4.3.8 LCD Panel
1. Remove the SSB as described earlier.
2. Remove the PSU as described earlier.
3. Remove the keyboard control panel as described earlier.
4. Remove the stand bracket as described earlier.
5. Remove the IR/LED as described earlier.
6. Remove the IR/LED as described earlier.
7. Remove the fixations screws that fix the metal clamps to
8. Remove all other metal parts not belonging to the panel.
9. Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
4.4 Assembly/Panel Removal (for 6007 series)
Instructions below only apply to the 42&47PFL6007D/30.
4.4.1 Stand
Refer to
1. Gently remove the black plastic casing [1] that covers the
2. Remove the Allen screws [1, 2] that secure the stand
Figure 4-10 Stand removal[1]
back to
div. table
TPM9.5A LA
from the bezel.
the front bezel. Take out those clamps.
Figure 4-10 and Figure 4-11
stand bracket, refer to Figure 4-10.
bracket and, pull out the stand downwards from the set,
refer to Figure 4-11.
4. EN 15
for details.
19341_102_121119.eps
121119
2012-Nov-30