Philips 32PFL5007D/30 Service Manual page 14

EN 14 4. TPM9.5A LA
4.3.1 Rear Cover
Refer to Figure 4-8 for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
2
2
2
2
4
4.3.2 Small Signal Board (SSB)
Refer to Figure 4-9 for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
2. Unplug all other connectors [2].
3. Remove all the fixation screws from the SSB [3].
4. The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
Figure 4-9 for details.
2012-Nov-30
Mechanical Instructions
2
2
1
1
1 1
4
4
4
Figure 4-8 Rear cover removal
back to
div. table
screws [2], [3], [4]that secure the rear cover. Refer to
Figure 4-8 for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
3
3
4
3
2
3
Figure 4-9 SSB removal
2
M4 × 12
2
1
M3 × 10
2
2 M3 × 6
3
3 × 10
2
4
4
19340_105_120806.eps
120820
3
1
3
19340_106_120806.eps
120820