Omron S8TS Series Manual page 12

S8TS
Output Voltage Adjuster (V.ADJ)
Do not exert excessive force on the output voltage adjuster
(V.ADJ). Doing so may break the adjuster.
Setting the adjuster to a setting less than 10% may cause the
undervoltage detection function to operate.
Bus Line Connectors
Do not apply sudden shocks (e.g., by dropping) to the Bus Line
Connectors. Doing so may result in damage.
DIN Track Mounting
To mount the Block on a DIN track, hook portion (A) of the Block
onto the track and press the Block in direction (B).
To dismount the Block, pull down portion (C) with a flat-blade
screwdriver and pull out the Block.
C
No Output Voltage
If there is no output voltage, it is possible that overcurrent protec-
tion or overvoltage protection is operating. It is also possible that
the latch protection circuit is operating due to the application of a
large surge, such as lightning surge. Confirm the 2 points below.
If there is still no output voltage, consult your OMRON representa-
tive.
• Checking for Overcurrent Protection:
Separate the load line and confirm that it is not in an overcurrent
state (including short-circuits).
• Checking for Overvoltage Protection or Latch Protection:
Turn the input power supply OFF, and then turn it ON again after
1 minute or more has elapsed.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. T022-E1-1
In the interest of product improvement, specifications are subject to change without notice.
OMRON Corporation
Industrial Automation Company
Measuring and Supervisory Controls Department
Shiokoji Horikawa, Shimogyo-ku
Kyoto, 600-8530 Japan
Phone: (81)75-344-7108 Fax: (81)75-344-7189
12
A
B
30 mm min.
Track stopper
S8TS
Printed in Japan
0701-2M (0701)