Electrical Connections - Dea TEO 700 Operating Instructions And Warnings

5 ELECTRICAL CONNECTIONS

Execute the wiring following the directions of the diagrams.
WARNING To ensure an appropriate level of electrical safety always keep the 230V power supply cables apart (minimum 4mm in the
open or 1 mm through insulation) from low voltage cables (motors power supply, controls, electric locks, aerial and auxiliary circuits
power supply), and fasten the latter with appropriate clamps near the terminal boards.
WARNING Connect to the power supply 230 V ~± 10% 50 Hz through a multi pole switch or a different device that can ensure multi pole
disconnection from the power supply, with a contact opening of 3 mm.
WARNING To connect the encoder to the control panel, use only a dedicated cable 3x0,22mm
PHOTO 1
N.O.
N.C.
RX
COM
TX
AC/24V
Wiring Diagram
START
uscita lampeggiante intermittente
intermittent flashing light output
sortie clignotant intermittente
Ausgang blinkend für Blinklampe
salida destellante intermitente
saída de luz intermitente
wyjście lampy ostrzegawczej świecenie przerywane
выход прерывистого проблескового фонаря
ROSSO NERO
RED BLACK
ROUGE NOIRE
ROT SCHWARZ
ROJO NEGRO
VERMELHO PRETO
CZERWONY CZARNY
КРАСНЫЙ ЧЁРНЫЙ
MOTOR
.
2
FLASH 24V
11