Switching Output X: Testing The Switching Output; Change Display Function Of The Status Led - Bosch Rexroth WGM Operating Instructions Manual

26/46 Operation
Bosch Rexroth AG, RE 51550-B/09.2019

5.1.7.6 Switching output x: Testing the switching output

A test of the switching output can be started in the following menu:
The following options are available:
Test possibility for the switching output
Options for setting
Normal operation of
the switching output
Options for setting
Normal operation as
frequency output
Important notice:
When the test is complete, set the function to
normal operation

5.1.7.7 Change display function of the status LED

The switching status of the output is indicated by the LEDs in the display.
The assignment of the LEDs to the switching output is shown in the following table:
Numbering Switching output x
LED
1
2
3
4
5
6
In the factory setting, the LED indicates the physical state of the PNP switching
output (switching output closed - LED illuminated).
It is possible that the logic function of the display shall be different from the physical
signal on the switching output. You can therefore also reverse this display in this
menu item (switching output open - LED illuminated).
to / /
OUi hNO hNC fNO
Permanently switch off
the switching output
to :
OUi fM
Output
Frequency 1 Hz
.
N.Op
Assignment with
2 switching outputs
Reserved for IO-Link
LED 2 - red
Reserved
Reserved
Reserved
Reserved
/ :
fNC
Permanently switch on
the switching output
Output
Frequency 100 Hz