Operating Noise Warning; Consumer Rights; Tampering Warning - Husqvarna FE 350s 2021 Owner's Manual

Please note that Husqvarna Motorcycles is entitled to reject warranty claims if your motorcycle or a part fails
due to misuse, negligence, an accident, participation in racing or similar events, improper maintenance or
unauthorized modifications.
Scope of the manufacturer's warranty
–
Five (5) years or 30,000 kilometers (18,641 miles), whichever occurs first.
If you have any questions regarding the manufacturer warranty for the exhaust monitoring system, please
address these to:
Husqvarna Motorcycles North America, Inc., c/o KTM North America, Inc., Customer Support, 1119 Milan Ave.,
Amherst, OH 44001, USA
Phone: (888) 985-6090
U.S. Environmental Protection Agency, 2000 Traverwood Drive, Ann Arbor, MI 48105, USA
California Air Resources Board, 1001 "I" Street, Sacramento, CA 95814, USA
2.9

Operating noise warning

This product should be checked for necessary repair or replacement parts if the motorcycle noise has
increased significantly through use. Otherwise, the owner may become subject to penalties under the
applicable ordinances.
2.10

Consumer rights

Warranty claims should be submitted to a Husqvarna Motorcycles workshop. If you are not satisfied, please
contact:
Husqvarna Motorcycles North America, Inc., c/o KTM North America, Inc., Customer Support, 1119 Milan Ave.,
Amherst, OH 44001, USA
Phone: (440) 985–3553
www.husqvarna-motorcycles.com
Husqvarna Motorcycles North America, Inc., c/o KTM Canada, Inc., 8701 Rue Samuel‑Hatt, Chambly, QC J3L
6V4, Canada
Phone: (450) 441-4451
www.husqvarna-motorcycles.com
Different rights may apply, according to national or regional legislation.
2.11

Tampering warning

Tampering with the noise control system is prohibited. Federal law prohibits the following acts or the causing
thereof:
1 The removal or rendering inoperative by any person other than for purposes of servicing, repair, or replace-
ment, of any device or element of design incorporated into any new vehicle for the purpose of noise control
prior to its sale or delivery to the ultimate purchaser or while it is in use, or
2 the use of the vehicle after such device or element of design has been removed or rendered inoperative by
any person.
Among those acts presumed to constitute tampering are the acts listed below:
1 Removal or puncturing of the main silencers, baffles, manifolds or any other components which conduct
emissions.
2 Removal or puncturing of parts of the intake system.
3 Lack of proper maintenance.
4 Replacing moving parts of the vehicle, or parts of the exhaust system or intake system, with parts other
than those specified by the manufacturer.
SAFETY ADVICE 2
11