Disposal Information - Dyson V10 Operating Manual

• Slide the large brush bar back onto the cleaner head, around the motor. The
end cap should be in the open position as shown. Once in place, rotate the end
cap back into the closed position.
• The end cap should be in the open position as shown. Once in place, rotate the
end cap back into the closed position.
• Close the fastener by turning a quarter clockwise. Ensure that the fastener is
fully turned and the brush bars are secure.
WASHING THE FILTER UNIT
Check and wash the filter unit, according to the instructions, to
maintain performance.
• Remove the filter unit by twisting anti-clockwise to the open position. Gently pull
away from the appliance.
• Wash the inside of the filter unit first; hold it upright under the cold water top
and agitate using a rotating motion.
• Wash the outside of the filter unit; fill the unit with cold water, place your hand
over the open end and shake gently.
• Repeat washing the inside and outside of the filter unit until the water runs clear.
• Gently tap the filter unit to remove any excess water and leave to dry with the
open end facing up.
• Leave the filter unit to dry completely for a minimum of 24 hours.
• Check that the filter unit is completely dry.
• To refit, return the filter unit to the open position and twist clockwise until it clicks
into place.
The filter unit may require more frequent washing if vacuuming fine dust or
using mainly boost suction.
Do not put any part of your appliance in a dishwasher, washing machine,
tumble dryer, oven, microwave or near a naked flame.
BLOCKAGES – AUTOMATIC CUT-OUT
• This appliance is fitted with an automatic cut-out.
• If any part becomes blocked, the appliance may automatically cut out.
• This will happen after the motor pulses a number of times (i.e switches on and
off in quick succession) and the blockage indicator LED will illuminate.
• Leave to cool down before looking for blockages.
• Ensure the appliance is disconnected from the charger before looking for
blockages. Failure to do so could result in personal injury.
• Clear any blockage before restarting.
• Refit all parts securely before using.
• Clearing blockages is not covered by your guarantee.
LOOKING FOR BLOCKAGES
The motor will pulse and the blockage indicator LED will illuminate when there is
a blockage. Please follow the instructions below to locate the blockage:
• Ensure the appliance is disconnected from the charger before looking for
blockages. Be careful not to pull the 'ON' trigger.
• Do not operate while checking for blockages. Doing so could result in
personal injury.
• Leave to cool down before looking for blockages.
• Beware of sharp objects when checking for blockages.
• To check for blockages in the main body of the appliance, remove the clear
bin following the instructions in the cleaning the clear bin section and remove
the blockage.
• If you cannot clear an obstruction you may need to remove the brush bars,
please follow the instructions below:
– To remove the soft roller cleaner head brush bars, please refer to the
'Washing the soft roller cleaner head brush bars' section. Remove the
obstruction and replace the brush bars as shown in the 'Washing the soft
roller cleaner head brush bars' section. Ensure that the fastener is fully
turned and the base plate and brush bars are secure before operating
the appliance.
– To remove the brush bar from the direct drive cleaner head or mini motorised
tool, use a coin to unlock the fastener and slide the brush bars out of the
cleaner head. Remove the obstruction. Replace the brush bar and secure
it by tightening the fastener. Ensure it is fixed firmly before operating
the appliance.
• This product has carbon fibre brushes. Take care if coming into contact with
them, as they may cause minor skin irritation. Wash your hands after handling
the brushes.
• Refit all parts securely before using.
• Clearing blockages is not covered by your guarantee.
CHARGING AND STORING
• This appliance will switch 'OFF' if the battery temperature is below 3°C
(37.4°F). This is designed to protect the motor and battery. Do not charge the
appliance and then move it to an area with a temperature below 3°C (37.4°F)
for storage purposes.
• To help prolong battery life, avoid recharging immediately after a full discharge.
Allow to cool for a few minutes.
• Avoid using the appliance with the battery flush to a surface. This will help it run
cooler and prolong battery run time and life.
BATTERY SAFETY INSTRUCTIONS
• If the battery needs replacing, please contact the Dyson Helpline.
• Use only Dyson chargers for charging this Dyson appliance.
• The battery is a sealed unit and under normal circumstances poses no safety
concerns. In the unlikely event that liquid leaks from the battery do not touch the
liquid and observe the following precautions:
– Skin contact – can cause irritation. Wash with soap and water.
– Inhalation – can cause respiratory irritation. Expose to fresh air and seek
medical advice.
– Eye contact – can cause irritation. Immediately flush eyes thoroughly with
water for at least 15 minutes. Seek medical attention.
– Disposal – wear gloves to handle the battery and dispose of immediately,
following local ordinances or regulations.
CAUTION
The battery used in this device may present a risk of fire or chemical burn if
mistreated. Do not short contacts, heat above 60°C (140°F), or incinerate. Keep
away from children. Do not disassemble and do not dispose of in fire.
ONLINE SUPPORT
• For online help, general tips, videos and useful information about Dyson.
www.sa.dyson.com/support

DISPOSAL INFORMATION

• Dyson products are made from high grade recyclable materials. Recycle
where possible.
• The battery should be removed from the product before disposal.
• Dispose of or recycle the battery in accordance with local ordinances
or regulations.
• Dispose of the exhausted filter unit in accordance with local ordinances
or regulations.
GUARANTEE TERMS & CONDITIONS
Please contact Ayan Trading (SA) or Jumbo Electronics Co. Ltd (LLC)(UAE) for
the terms and conditions of your guarantee.
Please keep your invoice to validate your guarantee.
16