Table of Contents
Advertisement
Operating Instructions
FOR FITTING INSTRUCTIONS SEE INSTALLATION SECTION.
ALL GRIDDLES ARE FITTED WITH FLAME FAILURE DEVICE FOR SAFETY AND SPARK
IGNITION FOR EASE OF LIGHTING
TO LIGHT BURNER:
*
1. Turn knob to
2. Push knob in and ignite gas by pressing ignition button to left of the on/off knob.
3. Keep ON/OFF knob pressed in for 15-20 seconds. Check gas is lit by looking through the
sight-hole on the front panel of the appliance.
4. Release ON/OFF knob, gas should stay lit, if gas goes out repeat (2) the pilot is now on. If
the unit fails to light within 1-minute abort the lighting process for at least 2 minutes to
allow gas to disperse.
5. Turn knob anti-clockwise to obtain main gas
factory and sealed. This must not be adjusted by user.
6. To turn burner off, turn knob in a clockwise direction all the way round to
7. We advise that the appliance should not be left unattended when switched on.
8. The appliances are designed for professional use by qualified people only.
9. There are no user serviceable parts.
10. Clean outer casing with warm soapy water. Do not use scouring pads.
It is recommended that Griddles be run on full gas after ignition for 10 minutes, then adjust
as necessary to obtain correct cooking temperature.
To remove any residue, use a scraper several times a day after cooking. Scaling will result if
this is not done. Empty the fat drawer and clean every day.
IN103-8
position
Parry-British Built for Purpose
. The lowest setting has been set at the
•
6
Advertisement
Table of Contents
