Gaspardo GENIUS Use And Assembly Instructions / Spare Parts page 5

1.0 INTRODUCTION
This manual gives all the specific information that you need for a
proper use of the equipment. After buying the instrument, read
the manual carefully and refer to it any time you have doubts on
how to use the equipment or when you have to carry out
maintenance operations. Keep the manual on the machine. If
this is not possible, keep it ready to hand. Regular operation
depends on the correct use and adequate maintenance of the
equipment. It is advisable therefore to observe scrupulously what
is described in order to prevent any inconveniences that could
prejudicate proper operation and duration. The equipment must
be used, maintained and repaired by trained personnel that have
been instructed on the dangers arising from its incorrect use. All
the safety regulations and provisions for technical safety,
occupational medicine and the Highway Code must also be
observed. The manufacture is not liable for any damage to
property or injury to persons due to modifications made to the
equipment by the user. It is just as important to keep to what is
described in this booklet since the Manufacturer declines all
responsibility due to negligence and non-observance of these
rules. At any rate the Manufacturer is available to assure imme-
diate and accurate technical assistance and all that may be
necessary for the improved operation and better performance of
the equipment.
1.1 GUARANTEE
On delivery, check that the equipment has not been damaged
during transport and that the accessories are integral and com-
plete.
POSSIBLE CLAIMS MUST BE PRESENTED IN WRITING WITHIN
EIGHT DAYS OF RECEIPT.
The purchaser will enforce his rights on the guarantee only when
he has respected the conditions concerning the benefit of the
guarantee, set out in the supply contract.
1.1.1 EXPIRY OF GUARANTEE
Besides what has already been set out in the supply contract,
the guarantee expires:
- If the limits set out in the technical data table are overshot.
- If the instructions set out in this booklet have not been carefully
followed.
- If the equipment is used badly, defective maintenance or other
errors by the client.
- If modifications have been carried out without written
authorization of the manufacturer and if non original spare parts
have been used.
cod. G19502880
2.0 SAFETY REGULATIONS AND
ACCIDENT PREVENTION
Carefully read all the instructions before using the equipment;
if in doubt, contact the technicians of the Manufacturer's dealer.
The manufacturer declines all responsibility for the non-
observance of the safety and accident prevention regulations
described below.
General norms
- The equipment is exclusively designed for a specific agricultural
use. Any other use is considered improper.
- In the event of improper use, the Manufacturer declines all
responsibility for any damage to persons and property. The
risks created by improper use are the sole responsibility of the
user of the equipment.
- Specific use also includes observance of the operating and
maintenance conditions laid down in this manual.
- The relevant generally accepted accident-prevention
regulations must be observed, in addition to the latest standards
relative to safety measures, occupational medicine and the
highway code.
- The Manufacturer declines all responsibility for unauthorized
modifications made to the equipment.
Maintenance in safety
During work and maintenance operations, use suitable perso-
nal protection gear:
Overalls
- Before performing work on the electrical system, disconnect
the battery.
- If welding operations need to be performed either on the tractor
or on the mounted equipment, disconnect the battery power
supply.
- Do not carry out maintenance or cleaning work before the
engine has been switched off, the hand brake has been put on
and the tractor has been blocked with a suitably sized stone
under each wheel.
- All maintenance work, adjustments and preparation for
operation, must be carried out with the power take-off of the
tractor disconnected, the seeder on the ground on its supporting
feet, the tractor not running, the wheels blocked and the key
turned off.
- The spare parts must correspond to the manufacturer's
specifications. Use only original spares.
g
ENGLISH
Gloves Shoes Goggles Helmets
31