Door; Unsatisfactory Cleaning And Corrosion - Miele PG 8591 Operating Instructions Manual

Door

Problem
The door is open a fraction
and cannot be closed
using the  button.
Door not closed properly
Warning! Cabinet hot. Open
anyway?
Obstruction sensor

Unsatisfactory cleaning and corrosion

Problem
There are white deposits
on the wash load.
Possible cause and solution
This is not a fault.
The Comfort door lock has opened the door slightly at the
end of the program.
Open the door. The door can now be closed completely

again using the  button.
Slamming the door can result in problems with the Comfort
door lock.
Open and close the door.

If the same error message appears again:
Contact Miele Service.

When the  button is pressed, the temperature in the
wash cabinet is over 60°C.
 When the door is opened, hot steam and process
chemicals can escape!
Open the door only when necessary.

The door was closed before the door lock rail was fully
retracted.
Open the door.

The door lock rail must be fully retracted before you

close the door again.
Possible cause and solution
The water softener is set too low.
Set the water softener to the correct water hardness.

There is no salt in the salt reservoir.
Refill with reactivation salt.

The quality of the water for the final rinse was insufficient.
Use demineralized water (DI) with a low conductivity.

If the machine is connected to a water demineralization

cartridge, check the conductivity level and replace resins
as necessary. If the machine is connected to a DI water
purification system, consult the manufacturer of the
purification system.
The water from the DI water connection is not sufficiently
demineralized.
Check the external demineralization system. If

necessary, replace the demineralization cartridge with a
new one.
Problem solving guide
127