NAPCO iSecure Installation & Programming Instructions page 14

Configure the IBR-TOUCH-WL (cont'd)
To connect through the customer's wireless router, check
6
Enable Wi-Fi; select the router name from the pull-down
and have the customer type their router Password (tap the
"Refresh" button to the right of the pull-down if the custom-
er's router is not listed). When finished, tap Save & Next>>.
8
As shown in the image below, the system will then
automatically try to connect the IBR-TOUCH-WL
locally through Wi-Fi, provided the Hub is con-
nected either by the wired Ethernet connection or
the Wi-Fi connection. When connected, tap Next.
If you selected Keypad Only, jump to step 11.
10
Upon connection to the Internet-based ac-
count for the iSecure system, the resulting
keypad shown in step 12 will be configured
for the payment plan selected by the custom-
er. For example, smart phone notifications
and camera video.
12
Be sure to verify the touchscreen display reflects the current status
of the security Hub. Note: The red text at the bottom right de-
scribes the connections.
In this example, the IBR-TOUCH-WL is connected to the Go-
Anywhere Smart Hub through its Wi-Fi connection.
14
All technical manuals are available in PDF format at
7
Wait until the message indicates the connection to
the customer's wireless router is complete, then tap
Next.
9
The IBR-TOUCH-WL will automatically attempt to
connect, through the "cloud", to the NAPCO iSe-
cure account. Enter your administrator account
User ID and Password and tap Finish.
11
If you selected Keypad Only in step 7, the virtu-
al security system keypad will appear (shown
below). Stop here -- you're finished!
If you selected Full Functionality, you're almost
finished...go to next step...
tech.napcosecurity.com
Napco iSecure Security System