Installing Your Dishwasher; Facing The Door; Balancing The Door; Water Connections - Brandt VI320BE1 Installation Instructions Manual

Installing your dishwasher

This dishwasher
must operate with a
wood panel.

Facing the door

To fit a door to match your units
onto the dishwasher's door, use the
installation template and
accessories supplied with your
machine.
Balancing the door (right and
left)
Adjust the tension on the springs, if
required, to compensate for the
weight of the facing panel. Adjust in
an identical fashion to the right and
to the left. The adjustment is easier
with the door closed.
Fix your dishwasher to the worktop
with two screws under the front
corner bracket.
If your worktop is marble or a
similar material, you can fasten
your dishwasher in place at the
sides using two brackets (available
from the After-Sales department or
from your dealer).
18
the
GB
Installing your dishwasher

Water connections

Important :
check the water's
hardness: all the
information you
require is provided in
the Chapter
"Adjusting the water
softener" in your
operating instructions
manual.
Tap: with threaded end, 20/27mm
dia. (3/4" BSP)
Flow: 10l/min. minimum
Pressure: 1 bar to 10 bars
(0.1 - 1 MPa)
In the event of high pressure, it is
advisable to fit a pressure regulator.
Your Water Company will give you
the necessary information.
Length of the water supply pipe
(standard unit): 1.50m
"Hazardous Voltage" symbol
(depending on the model)
the hose is fitted with an electrical
device
Connecting the hot water:
Check that your original hose is
designed for connection to the hot
water supply (red marking on the
hose).
If you use a self-
piercing tap, check that
there is sufficient water flow.
Check that the
seal is fitted
0,1 - 1 MPa
and that the
connection is
tight.
When the tap is on the left-
hand side of the machine, use the
"anti-kinking" hook supplied with the
machine to avoid any risk of the
supply hose* kinking while you are
fitting your dishwasher.
(* For large diameter safety hoses-
depending on the model)
If necessary, you can alter the
hose's direction. To do this, loosen
the connection at the bottom left
on the rear of the machine and
swivel it as necessary. Fully tighten
the connection again and check
that there are no leaks.
For dishwashers fitted
with safety hoses:
You must remove the
protective cover (see
the drawing opposite)
to alter the hose's
direction. To do this,
loosen the two
screws (end fitting
T20), remove the
protective cover,
position the
connection in the
direction you wish and then
replace the protective cover.
When you are making a
new installation, you must
use a new hose to connect the
machine to the water supply: you
must not re-use the old hose.
GB
19