Table of Contents
Advertisement
SET UP DEHUMIDIFIER FOR INSTALLATION
DUCT COLLARS
Use the screws in the parts bag to attach the duct collars to the
inlet and outlet of the dehumidifier . The outlet collar has a backflow
damper . See Figure 3 .
CONTROL LOCATION
The on-board control, located on the front of the
dehumidifier, can be relocated to the top of the
dehumidifier if the control can not be seen/accessed
in the front orientation .
To move the control:
1. Remove the top control panel cover .
2. Remove the filter access door and filter .
3. Detach the on-board control by removing the four
(4) screws around the control . NOTE: Use one
hand to support the back of the on-board control
when removing .
4. Keep the control in the unit and relocate to the
top access hole .
5. Secure the control with the same four screws
used to attach the control to the front of the unit .
6. Secure the control panel cover to the front of the
unit .
4
(CONTINUED)
FIGURE 3 – Install Duct Collars
INLET
DUCT
COLLAR
FIGURE 4 – Control Location
CONTROL
CONTROL
PANEL COVER
OUTLET COVER
OUTLET DUCT
COLLAR W/BACK
DRAFT DAMPER
END DISCHARGE
CONTROL
PANEL COVER
CONTROL
FILTER ACCESS DOOR
90-1909
90-1884
Advertisement
Table of Contents
