Siemens SIMATIC IOT2050 Starterkit Product Information page 21

Procedure
NOTICE
Install Input/Output Module
Do not under any circumstances insert the module incorrectly. Ensure that the contact pins
of the module connect correctly with the terminal strips of the motherboard.
1. Loosen the shield cover. Carefully press with the blade of a flat-blade screwdriver in the
marked recesses and carefully pull on the appropriate place on the shield cover.
2. Remove the shield cover.
3. Insert the mounting clamp into the marked boreholes on the motherboard shown below.
Note: Insert the marked side of the mounting clamp into the motherboard.
SIMATIC IOT2050 Starterkit
Product Information, 06/2021, A5E50831253-AA
Installing the IOT2000 Input/Output Module
21