Advertisement
3-5. Setting up WPS-PIN mode (MAC-56 series only)
1. Before using WPS-PIN mode, the PIN code of the Wi-Fi interface needs to be set
on the Router. Refer to Router's manual to enter the PIN.
2. Push MODE switch for 14 seconds and release to set WPS-PIN mode.
3. NET and UNIT LEDs flash (every 5 sec) when the connection is completed.
Notes:
● Please make sure that the Router supports WPS-PIN mode.
Not all Routers supports WPS-PIN mode.
● Push RESET switch for 2 seconds to reset the Wi-Fi interface if LED indication
does not change after 5 minutes.
4. LED pattern
: ON
: OFF
● Software initializing
Description
Firmware updating
Firmware downloading
Reset to the factory default
● Wireless setting
Description
Access Point mode activated
WPS-PUSH mode activated
WPS-PIN mode activated
(MAC-56 series only)
Pairing process via WPS completed
Pairing process via WPS failed
● Connection to MELCloud in progress
Description
Communicating with MELCloud, and
starting up indoor unit communication
Communicating with MELCloud, and
communicating with indoor unit
(*1) Details of flash pattern
• Every 0.5 sec: Searching for MELCloud.
• Every second: Registering the information of the Wi-Fi interface to MELCloud.
• Every 5 sec: Communicating with MELCloud.
: Flashing
ERR
(Orange)
ERR
(Orange)
(5 sec)
ERR
(Orange)
NET
MODE
(Green)
(Orange)
(every second)
(every second)
NET
MODE
(Green)
(Orange)
(every 5 sec)
(every second)
(every 0.5 sec)
(5 sec)
NET
MODE
(Green)
(Orange)
(*1)
(*1)
UNIT
(Green)
UNIT
(Green)
(every 5 sec)
UNIT
(Green)
(every 5 sec)
EN-6
Advertisement
