Cli Commands And Parameters; Overview Of Cli Commands And Parameters; Cli Command Reference; Table 17 List Of Commands - Vaisala AQT530 Configuration Manual

AQT530 Configuration Guide
5. CLI commands and
parameters
5.1 Overview of CLI commands and
parameters
AQT530 CLI commands include the following:
• AQT530 identification commands: motd, uname
• System control command: reboot
• Configuration commands: date, initconf, set, show, write
• Measurement output command: meas
• LPC identification command: lpc
• Device status command: status
The AQT530 parameters include a set of read-only and read/write parameters.
Read/write parameters:
• Modbus interface configuration parameters
• Temperature unit parameter
• Linear correction parameters for gases
• Linear correction parameters for particles
Read-only parameters:
• Device identification parameters
• Base module identification parameters
• Base module monitoring parameters
• Gas measurement configuration and diagnostics parameters
• LPC parameters
• Temperature and humidity probe (TH) probe parameters
More information
‣ CLI command reference (page 28)
‣ CLI parameters (page 36)
5.2 CLI command reference
The commands are for use in a standard terminal program (command-line interface, CLI).
Table 17 List of commands
Command
date [<YYYY-MM-
DDThh:mm:ss>]
28
Table 25 (page 37)
Table 28 (page 38)
Table 30 (page 39)
Table 32 (page 39)
Description
Prints or changes current date and
time.
Table 24 (page 36)
Table 26 (page 37)
Table 27 (page 38)
Table 29 (page 38)
Table 33 (page 39)
Reference
Setting date ( date command)
(page 30)
M212572EN-C
Table 31 (page 39)