List Of Serial Commands; Table 5 List Of Serial Commands - Vaisala HUMICAP HMT130 Manual

HMT130 User Guide
7. To open the connection window and start using the serial line, select Open.
If PuTTY is unable to open the serial port you selected, it shows you an error
message instead. If this happens, restart PuTTY and check the settings.
4.5 List of serial commands
All commands can be issued either in uppercase or lowercase.
The notation <cr> refers to pressing the carriage return (ENTER) key on your computer
keyboard. Enter a <cr> to clear the command buffer before starting to enter commands.
Whenever you change any of the parameters and want to store the changes permanently, use
the SAVE command.
Measurement parameters are referred to as quantities in the transmitter's
software.
Table 5 List of serial commands
Command
?
??
ACAL
ADDR
AERR
AMODE
AOUT
ASEL
ATEST
CALCS
CDATE
CLOSE
CRH
CRHCLR
CT
28
Description
Show transmitter information
Show transmitter information (POLL mode)
Calibrate analog outputs
Set/show device address
Set/show analog output error levels
Set/show analog output mode
Show analog output status
Set/show analog output parameters and scaling
Test analog outputs
Set/show measured parameters
Set/show calibration date
Start POLL mode
Calibrate probe RH
Restore probe RH factory calibration
Calibrate probe T
M211280EN-D