Advertisement
Customer Care Europe, Middle East & Africa
SCCE Training Group
Figure 2-3
Now by pressing on the squares with the three dots you have to choose a MCU Image file and PPM file for your phone.
At this point it is not necessary to choose the right PPM file, because this SW-update is used only to make it possible to power
the phone on.
After selecting the two files you have to press the Flash-button to start the SW-update. Next message will be the following:
Figure 2-4
Select Yes and the SW-update will start. If your phone has no fault and the new FLASH/EEPROM was well soldered, you will get
order to Restore Default User Settings – press ok. After that you will get message, that flashing completed: press ok.
Now close the Flash Phone window by pushing the Close button.
© NMP 2002
CONFIDENTIAL
NHM—2/5/6
3410
Date 20.11.2002
Checked by:
Customer Care E&A
15 (44)
Repairhints
Version 4.0 Approved
Approved by:
SCCE Training Group
Advertisement
