ECS P6VPA2 Manual page 54

AGP & P2P Bridge Control
Scroll to AGP & P2P Bridge Control and press <Enter> to view the
following screen:
CMOS Setup Utility – Copyright © 1984 – 2000 Award Software
AGP Aperture Size
AGP Mode
AGP Driving Control
x AGP Driving Value
AGP Fast Write
AGP Master 1 WS Write
AGP Master 1 WS Write
↑ ↓ → ← : Move Enter : Select
F5:Previous Values
AGP Aperture Size
This item defines the size of the aperture if you use an AGP graphics
adapter. It refers to a section of the PCI memory address range used
for graphics memory. We recommend that you leave this item at the
default value.
AGP Mode
This item allows you to set the AGP speed at 1X, 2X, or 4X. Enabling
AGP-4X Mode can greatly improve the display speed. If your graphics
dis play card does not support this feature, you need to disable this item.
AGP Driving Control
This item can be used to signal driving current on AGP cards to auto or
Manual. Some AGP cards need stronger than normal driving current in
order to operate. We recommend that you set this item to Auto by
default.
•
AGP Driving Value: When the previous item AGP Driving
Control is set to Manual, you can use this item to set the AGP
current driving value.
AGP Fast Write
This item allows you to enable or disable the caching of display data for
the video memory of the processor. Enabling can greatly improve the
display speed. If your graphics display card does not support this
feature, you need to disable this item.
AGP & P2P Bridge Control
64M
4X
Auto
DA
Disabled
Disabled
Disabled
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults
48
Item Help
Menu Level
F1:General Help
F7:Optimized Defaults
Default: 64 MB
Default: 4X
Default: Auto
Default: Disabled