Table of Contents
Advertisement
2.7.2 If you have selected Discard in Step 2.6, a "Discard your settings"
2.8 Operation:
2.8.1 If you have your SPS settings ready, you may change the SPS-Off to
2.8.2 SPS Off：If you turn off the SPS mechanism, the set of Lamp
2.9 Notice:
2.9.1 When the SPS Setting 3 is selected on the menu, you can still adjust
2.9.2 The Default setting is the SPS setting by factory default.
5-8 Storage after Use
1. Fold the arm and the camera head until they touch the stage.
2. Turn the camera until it is parallel with the stage.
3. Turn the upper lamps toward the supporting arms.
4. Insert the remote control into the slot on the right of the Digital Presenter.
5. Fold them to both sides of the Digital Presenter until they lock in both sides.
messages appears for three seconds. Then the screen to the one as
shown in 2.2. You may select
control to return to Layer 1; or, select
message appears. Then the screen returns to the one as shown in
Step 2.2.
the one you want after the presenter has been switched on. In such a
way, the Lamp parameters may be loaded for service.
parameters at your last presentation will be used.
the brightness and WB to meet the varied surrounding condition.
However, your modification will not be saved; that is, the values you
have specified in your SPS selection will be loaded the next time the
presenter is switched on.
Figure: 5–3
or press Menu on the remote
17
to configure another lamp.
Advertisement
Table of Contents
