Product Description And Intended Use; Safety Instructions - FIAM. COBRA 016 Product Information

COBRA Umbrella/Stick Stand
EN
Art. 016
Read this information carefully before using the product and keep it for
future reference. Failure to comply carefully with the instructions which
follow may put the safety of the product and its users at risk.

Product description and intended use

1
• Product description and composition
The COBRA Umbrella/Stick Stand - Art. Code 016 is a Umbrella/Stick Stand intended as an item of indoor furniture. It is
manufactured from curved float plate glass. The COBRA Umbrella/Stick Stand was produced at the FIAM ITALIA SPA factory at
Via Ancona 1/B, 61010 Tavullia (PU), Italy - Tel: +39.0721.20051 - Fax: +39.0721.202432 - www.fiamitalia.it
• Intended use
The article known as COBRA is designed and built to serve as a Umbrella/Stick Stand for indoor use and must therefore be used
only for this purpose and no other.
For more information about the product's intended use please refer to section "2) SAFETY INSTRUCTIONS".

Safety instructions

2
To ensure that our product is used in the conditions of the utmost safety, we urge you to comply with the safety instructions
provided below. If in doubt or if you require further information concerning the use of the product, please contact us on the
telephone numbers stated in this document.
• Transporting and storing the COBRA Umbrella/Stick Stand in the original packaging
The COBRA Umbrella/Stick Stand, in its original packaging, must be transported taking the greatest care to prevent knocks and
shaking. It must be stored indoors in a dry place.
Place the COBRA Umbrella/Stick Stand in the original packaging, in the horizontal position. The arrows on the label on the
packaging must be vertical and pointing upward.
Never place weights or loads in excess of 40 Kg on the original packaging, since exceeding this weight may cause the breakage
of the article.
The COBRA Umbrella/Stick Stand in the original packaging weighs about 22 kg.
It must therefore be placed on surfaces capable of supporting its weight.
• Removing the packaging - assembly
To remove the original packaging of the COBRA Umbrella/Stick Stand, proceed as follows.
a) Place the packaging crate horizontal. The arrows on the labels on the outside must be vertical and pointing upward.
b) Open the packaging crate and remove the sheets of polystyrene. Do not use hammers, saws, cutters or other tools which may
damage the COBRA Umbrella/Stick Stand.
c) Remove the COBRA Umbrella/Stick Stand from its packaging. Wear gloves which assure a good grip on the float glass.
6/16