Advertisement
NO.1 "LINKOK "didn't show up when pressing the function button.
A:
1.Please check whether tightly plug in USB cable with USB port and with the USB
connector, the USB cable is right cable from our standard accessories.
2. Please check whether keep the gimbal off before upgrading.
3. Please check whether choose the right COM number and baud rate as 115200.
4. Please check whether press the function button after clicking on "OPEN
COM" button at the right step.
If you did all the things right, please replace a new USB cable and USB
connector ,try it again.
NO.2 When"Link OK"showing up, click on"Start",but no luck,"SEND
FAIL"just show up to remind me the update don't work.
A: It happened because you didn't hold the function button for enough time,
and the power didn't start well. Please press and hold the function button at
step 13 till the screen fully light up.
NO.3 After clicking on "UPDATE START", "send block 10..." show up in the
interface , but "SEND FAIL" happen during the update.
A: If "SEND FAIL" shows up during the update, there may be something
wrong with the connection between control boards.
Please try to start update again, if the same issue happen, please kindly send back
to us for repair.
END
——
——
Note: We reserve the right to change this manual at any time! Also, the latest
edition will be shown on our official website www.feiyu-tech.com.
Guilin Feiyu Technology Incorporated Company www.feiyu-tech.com service@feiyu-tech.com
Guilin Feiyu Technology Incorporated Company
FAQ
- 9 -
Advertisement
