Table of Contents
Advertisement
9. ATTACHING THE FAN
BLADES
CAUTION: Remove 5 rubber packing mounts
and discard before installation.
Step 1. Attach the blade to the blade bracket
using the screws and fiber washers as shown
in Figure 17. Start screw into bracket. Repeat
for the two remaining screws.
Step 2. Tighten each screw. Make sure the
blade is straight.
Step 3. Fasten blade assembly to motor using
the screws supplied. (Fig. 17)
10. INSTALLING THE
LIGHT KIT
NOTE: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove the plug from the switch
housing. Attach the light kit to the switch
housing by feeding the light kit wires (black
and white) through the hole of switch housing
cover and then screw it onto the switch
housing cover by nut & lock washer. Be sure it
is tight enough to prevent light kit from
vibrating loose.
Step 2. Locate two single white and blue wires
in the switch housing labeled "FOR LIGHT".
Make the polarized plug connections:
- White to white
- Blue to black
Screws
Plug
8
Screws with
fiber washers
Blades bracket
Figure 17
Wire connectors
Nut
Washer
Figure 18
Blade
Light kit
Advertisement
Table of Contents
