Table of Contents
Advertisement
CLOSE-TO-CEILING INSTALLATION
1. Remove the decorative canopy bottom
cover from the canopy. (Fig. 8)
2. Pass the 120-volt supply wires through the
center hole in the ceiling hanger bracket as
shown in Fig. 5.
3. Secure the hanger bracket to the ceiling
outlet box with the screws and washers
provided with your outlet box.
4. Place the ceiling canopy over the collar at
the top of the motor. Align the mounting
holes with the holes in the motor and fasten
using the screws and lock washers
provided (Fig. 9).
5. Tighten the mounting screws securely. (Fig.
9)
WARNING: Failure to completely tighten the
three screws in step 5 could result in fan
loosening and possibly falling.
6. Hang the fan on the hook of the hanger
bracket. Be certain that the canopy is fully
locked into hook as shown in Fig. 10. This
will allow you to make the electrical
connections.
Collar
Hook
5
Canopy
Canopy bottom cover
Figure 8
Screw and
lock washer
Canopy
Figure 9
Figure 10
Advertisement
Table of Contents
