Table of Contents
Advertisement
5. HANGING THE FAN
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
NOTE: This ceiling fan is supplied with two
types of hanging assemblies; the standard
ceiling installation using the downrod with ball
and
socket
mounting
to-ceiling" installation. The "close-to-ceiling"
installation is recommended in rooms with less
than 8-feet ceilings or in areas where
additional space is desired from the floor to the
fan blades.
STANDARD CEILING INSTALLATION
Step 1. Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket as
shown in Fig. 5.
Step 2. Secure the hanger bracket to the
ceiling outlet box with the screws and washers
provided with your outlet box.
Step 3. Remove the hanger pin, lock pin and
set screws from the top of the motor assembly.
Step 4. Route wires exiting from the top of the
fan motor through the couping cover, canopy
and then through the ball/downrod. (Fig. 6)
Step 5. Align the holes at the bottom of the
downrod with the holes in the collar on top of
the motor housing. Carefully insert the hanger
pin through the holes in the collar and
downrod. Be careful not to jam the pin against
the wiring inside the downrod. Insert the
locking pin through the hole near the end of
the hanger pin until it snaps into its locked
position, as noted in the circle inset of Fig. 6.
Step 6. Tighten two set screws on top of the
fan motor firmly. (Fig. 6)
Step 7. Place the downrod ball into the hanger
bracket socket. (Fig. 7)
and
the
"close-
CUL Listed
electrical box
Hanger
bracket
Mounting screws
with washers
(supplied with
electrical box)
Downrod
Coupling cover
Hanger pin
Registration slot
4
120V Wires
Hook
Figure 5
Canopy
Set screws
Figure 6
Figure 7
Locking
pin
Advertisement
Table of Contents
