Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kendal AC-18552
Summary of Contents for Kendal AC-18552
-
Page 2: Tools And Materials Required
1. TOOLS AND MATERIALS REQUIRED Philips screw driver Blade screw driver 11 mm wrench Step ladder Wire cutters 2. PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items; Blade set (5) Hanger bracket Canopy Downrod Coupling cover Fan motor assembly... -
Page 3: Safety Rules
3. SAFETY RULES 1. To reduce the risk of electric shock, insure 8. Avoid placing objects in the path of the electricity has been turned off at the circuit blades. breaker or fuse box before beginning. 9. To avoid personal injury or damage to the 2. -
Page 4: Mounting Options
4. MOUNTING OPTIONS If there isn't an existing CUL listed mounting box, then read the following instructions. Disconnect the power by removing fuses or turning off circuit breakers. Outlet box Secure the outlet box directly to the building structure. Use appropriate fasteners and Figure 1 building materials. -
Page 5: Hanging The Fan
5. HANGING THE FAN REMEMBER to turn off the power. Follow the steps below to hang your fan properly: CUL Listed electrical box NOTE: This ceiling fan is supplied with two types of hanging assemblies; the standard Hanger bracket ceiling installation using the downrod with ball 120V Wires socket mounting... - Page 6 CLOSE-TO-CEILING INSTALLATION Canopy 1. Remove the decorative canopy bottom cover from the canopy. (Fig. 8) 2. Pass the 120-volt supply wires through the Canopy bottom cover center hole in the ceiling hanger bracket as shown in Fig. 5. Figure 8 3.
-
Page 7: Installation Of Safety Support
6. INSTALLATION OF SAFETY SUPPORT An additional safety support is provided to Hanger bracket Safety cable prevent the fan from falling. Secure the safety cable to the ceiling joist with screw and washer, as illustrated in Figure 11. 7. MAKE THE ELECTRIC Figure 11 CONNECTIONS POWER LINES 120V... - Page 8 WARNING: TO REDUCE THE RISK OF POWER LINES 120V FIRE, ELECTRIC SHOCK, OR OTHER LIGHT PERSONAL INJURY. MOUNT FAN ONLY GREEN ON AN OUTLET BOX OR SUPPORTING GROUND SYSTEM MARKED ACCEPTABLE FOR FAN WIRING SUPPORT. GROUND TO MOUNTING BRACKET OR DOWNROD BLEU 8.
-
Page 9: Attaching The Fan Blades
9. ATTACHING THE FAN BLADES CAUTION: Remove 5 rubber packing mounts and discard before installation. Step 1. Attach the blade to the blade bracket Screws with using the screws and fiber washers as shown fiber washers in Figure 17. Start screw into bracket. Repeat for the two remaining screws. - Page 10 Step 2. While holding the light kit assembly under your fan, snap together the wire connection plugs. Step 3. Carefully push all wires back into the switch housing, then install the light kit assembly onto the mounting plate with 3 screws provided.
- Page 11 11. FAN WITHOUT LIGHT (OPTIONAL) Step 1. Attach the plastic plug to the switch housing. Step 2. Holding the switch housing under your fan, snap together the wire connection plugs. Step 3. Install the switch housing to the mounting plate with screws provided. (Fig. 20) 12.
-
Page 12: Care Of Your Fan
13. CARE OF YOUR FAN Here are some suggestions to help you maintain your fan. 1. Because of the fan's natural movement, some connections may become loose. Check the support connections, brackets, and blade attachments twice a year. Make sure they are secure. -
Page 13: Troubleshooting
14. TROUBLESHOOTING Problem Solution Fan will not start. 1. Check main and branch circuit fuses or breakers. 2. Check line wire connections to the fan and switch wire connections in the switch housing. Fan sounds noisy. 1. Make sure all motor housing screws are snug. 2.