Table of Contents
Advertisement
Step 2. While holding the light kit assembly
under your fan, snap together the wire
connection plugs.
Step 3. Carefully push all wires back into the
switch housing, then install the light kit
assembly onto the mounting plate with 3
screws provided. Be sure to tighten all screws.
(Fig. 19)
Step 4. Install 3x40 Watt E12 B10.5
candelabra bulbs (not included).
Step 5. Mount the glass shade to the light
fixture by unscrewing partway the thumb
screws on the glass holder, insert the glass,
then gently tighten the thumb screws by hand
evenly to the glass. DO NOT OVER
TIGHTEN. (Fig. 20)
Step 6. Restore power and your light kit is
ready for operation.
Mounting plate
Light kit assembly
Bulbs
9
Wire connection plugs
Figure 19
Glass shade
Figure 20
Screws
Thumb
screws
Glass
holder
Advertisement
Table of Contents
