Table of Contents
Advertisement
11. FAN WITHOUT LIGHT
KIT
(OPTIONAL)
Step 1. Attach the plastic plug to the switch
housing.
Step 2. Holding the switch housing under your
fan, snap together the wire connection plugs.
Step 3. Install the switch housing to the
mounting plate with screws provided. (Fig. 20)
12. OPERATING
INSTRUCTIONS
NOTE: Wait for fan to stop before changing
the setting of the slide switch.
Turn on the power and check the operation of
your fan.
1. 3-speed pull chain- it controls the fan speed
as follows: 1 pull- High, 2 pulls- Medium, 3
pulls- Low, and 4 pulls- Off.
Speed settings for warm or cool weather
depend on factors such as the room size,
ceiling height, number of fans, and so on.
2. Light pull chain it controls the light in "ON"
or "OFF".
The Reverse switch is located on the switch
housing. Slide the switch to the Left for warm
weather operation. Slide the switch to the
Right for cool weather operation.
Warm weather - (Forward) A downward air
flow creates a cooling effect as shown in
Figure 21. This allows you to set your air
conditioner on a higher setting without
affecting your comfort.
Cool weather - (Reverse) An upward airflow
moves warm air off the ceiling area as shown
in Figure 22. This allows you to set your
heating unit on a lower setting without
affecting your comfort.
Mounting plate
Switch housing
10
Wire Connection
Plugs
Screws
Figure 20
Figure 21
Figure 22
Advertisement
Table of Contents
