HydroTherm H Series Quick Start Manual

HYDROTHERM
H - SERIES TOWEL RAIL
H2 Model
Width
See Below
HEIGHT: 700mm + Hardwire
WIDTHS: 400, 500, 600, 700
800mm
FINISH: Chrome / Powder Coat
WATTAGE: 70 - 200 Watt
TUBE DIAMETER: 25mm / 19mm
FEATURES
Replaceable Element Heating element easily replaced
Ensures ultimate thermal conductivity and
Copper Tube
radiation.
Additional clustered bars provide enhanced heat
transfer, ideal for drying and warming towels.
E cient Design
Subject to sizing, can be used to provide ambient heat
Local Product 100% Australian owned and manufactured
Warning:
This appliance is not intended for use by young children or infirm persons without supervision.
Young children should be supervised to ensure they do not play with this appliance
Caution:
Towel Rail must be installed so that the bottom rail is at least 600 mm above the oor to avoid a hazard for children.
The cord extension set must be positioned so that it is not subject to splashing or ingress of moisture .
The supply shall have means for disconnection with an air gap in all active conductors incorporated in the xed
wiring according to the Wiring Rules in AS/NZS 3000:2000
Tel: +61 3 9464 4622
HEIGHT: 1100mm + Hardwire
WIDTHS: 400, 500, 600, 700
FINISH: Chrome / Powder Coat
WATTAGE: 100 - 250 Watt
TUBE DIAMETER: 25mm / 19mm
Manufactured by Hydrotherm Australia , 96 Commercial Drive Thomastown Victoria 3074
Fax: +61 3 9464 4722
H3 Model
Width
See Below
800mm
SPECIFICATIONS
Models
Materials
Element
Power Cable
Safety rating
Finish
Standards
Web: www.hydrotherm.com.au Email: info@hydrotherm.com.au
H4 Model
Width
See Below
HEIGHT: 1500mm + Hardwire
WIDTHS: 400, 500, 600, 700
800mm
FINISH: Chrome / Powder Coat
WATTAGE: 100 - 300 Watt
TUBE DIAMETER: 25mm / 19mm
Electric / Non-Electric
Made entirely from Copper Tube with Brass
Fittings
Low wattage, replaceable water element
Bottom of unit (only) left or right hand side
IPX5 (allows for installtion in zone 1 & 2 of
bathroom)
High Polish Chrome Plate
AS/NZS:3350
CAUTION