HydroTherm TR Series Manual

HydroTherm TR Series Manual

Towel rail
Hide thumbs Also See for TR Series:

Advertisement

Quick Links

T O W E L
Width
See Below
HEIGHT: 700mm + Hardwire
WIDTHS: 400, 500, 600, 700
800, 900mm
FINISH: Chrome / Powder Coat
WATTAGE: 70 - 200 Watt
Tube Diameter: 25mm / 19mm
FEATURES
Heating element easily replaced
Replaceable Element
Ensures ultimate thermal conductivity and
Copper Tube
radiation
Perfects minimaist design and practicality.
Generous gaps allow bulky fabrics to be draped
Style and Simplicity
over with ease
Local Product
100% Australian owned and manufactured
Warning:
This appliance is not intended for use by young children or infirm persons without supervision.
Young children should be supervised to ensure they do not play with this appliance
Caution:
Towel Rail must be installed so that the bottom rail is at least 600 mm above the floor to avoid a hazard for children.
The cord extension set must be positioned so that it is not subject to splashing or ingress of moisture .
The supply shall have means for disconnection with an air gap in all active conductors incorporated in the fixed
wiring according to the Wiring Rules in AS/NZS 3000:2000
R A I L S
HEIGHT: 1100mm + Hardwire
WIDTHS: 400, 500, 600, 700
FINISH: Chrome / Powder Coat
WATTAGE: 100 - 250 Watt
TUBE DIAMETER: 25mm / 19mm
Manufactured by Hydrotherm Australia , 96 Commercial Drive Thomastown Vi
Tel: +61 3 9464 4622
Fax: +61 3 9464 4722
HYDROTHERM
TR - SERIES TOWEL RAIL
Width
See Below
800, 900mm

SPECIFICATIONS

Recommended use
Materials
Element
Power Cable
Safety rating
Finish
Standards
Web: www.hydrotherm.com.au
See Below
HEIGHT: 1500mm + Hardwire
WIDTHS: 400, 500, 600, 700
800, 900mm
FINISH: Chrome / Powder Coat
WATTAGE: 100 - 300 Watt
TUBE DIAMETER: 25mm / 19mm
Domestic, hotel and commercial
Made entirely from Copper Tube with Brass
Fittings
Low wattage, replaceable water element
Bottom of unit (only) left or right hand side
IPX5 (allows for installtion in zone 1 & 2 of
bathroom)
High Polish Chrome Plate
AS/NZS:3350
CAUTION
toria 3074
c
Email: info@hydrotherm.com.au
Width

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TR Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for HydroTherm TR Series

  • Page 1 The supply shall have means for disconnection with an air gap in all active conductors incorporated in the fixed wiring according to the Wiring Rules in AS/NZS 3000:2000 Manufactured by Hydrotherm Australia , 96 Commercial Drive Thomastown Vi toria 3074...
  • Page 2 160mm gap The TR series perfects simplistic design and practicality. The evenly 700 mm 400 mm spaced rails make the TR Series ideal for drying towels. Its generous gaps allow bulky fabrics to be draped over with ease. 150 mm MODELS...
  • Page 3 WALL WARNING Hydrotherm take pride in the fact that all rails are individually hand made. Due to this fact some measurements may not be exact. PLEASE READ INSTRUCTIONS CAREFULLY and do not force towel rail into bracket if position of wall flange is not accurate.
  • Page 4 DOUBLE HARD-WIRED VERSION DOUBLE HARD-WIRED VERSION HARD WIRING Hydrotherm recommends that all hard-wired heated towel rails be connected to a light switch or timer. Connecting hard-wired heated towel rails to a light switch or timer will prolong the life of the electric element and reduce energy consumption.
  • Page 5 Please note: Hydrotherm advise that the unit be removed from the wall and turned upside down to ensure that water does not spill. Ensure element always remains at bottom of towel rail...

This manual is also suitable for:

Tr1Tr2Tr3

Table of Contents