Wall Installation - Cornelius CANYON Assembly Instructions Manual

5
Before uncoiling the wall, make sure the pre-punched holes for the
skimmer and pump return are at the top and facing the planned lo-
cation of your filter.
PLANKS
Begin inserting the wall into the bottom wall tracks in the middle of
a joiner plate. At first, the wall should be kept in place with one or
two support bars (or extra persons).
End
WALL
JOINER PLATE

WALL INSTALLATION

SAND
SUPPORT BAR
SKIMMER HOLE
PUMP RETURN
HOLE
BOTTOM TRACK
One person should uncoil the wall on a beam or a plank while a
second person inserts it in the bottom wall tracks. Do not uncoil
more than 3 m (10') of wall before you install a support bar to re-
inforce the structure.
Once the wall is completely uncoiled, you may find that it is too long
or that both ends do not meet by a few centimetres. If such is the
case, you must gently push the wall in or out. If this does not work,
roll up the wall again, realign the grooves and uncoil the wall once
more. If the spread is too wide, measure the wall and check it
against the following chart.
When you prepare to join the ends of the wall, make sure the end
that is reinforced by the fold is inside the circle, facing the liner and
that the other end faces outward (See Illustration 5.1). When the
wall joint is screwed, install the round stabiliser on top of it.
IMPORTANT: Do not use impact gun!
Minimum clamping force of 60inch pounds to maximum of 85 inch
pounds.
Illustration 5.1
BOLT
Inside pool
End
Outside pool
NUT