Honeywell X-618 Installation Manual page 23

Figure 10 Connection Diagram of Amplifier and Control Port of X-DCS3000
2. Connect the DA audio output to the DCS
a. Strip one end of the prepared audio output cable jacket by 10mm, and feed the cable
through the protective cover of the power amplifier, as shown in Figure 11.
Figure 11 Schematic Diagram of a Feeding the Audio Output Cable through the Protective
b. Take the end of the cable that was fed through the protective cover of the power amplifier
wiring terminal and connect the cable to the power amplifier output wiring terminal (7P
green phoenix tail seating 5.08mm), and tighten the screws. Refer to Figure 12.
Figure 12 Connecting the Audio Output Cable to the Power Amplifier Input Wiring Terminal
c. Feed the other end of the audio output cable through the DCS protective cover of the
terminal.
d. Connect the end of the cable that was fed through the protective cover of the DCS to the
power amplifier input wiring terminal (4P green phoenix tail seating 5.08mm), and tighten
the screws.
e. Insert the power amplifier audio output wiring terminal of the installed audio output cable
into the DA audio output port.
Terminal Cover
17