Advertisement
Installation Steps, Continued
Standard Direct Wire Installation Continued
STEP FOUR
Connect the accessory cable and the power bank to the camera. When routing cables, it is
recommended to route the power bank cable with the accessory cable to the fuse panel and
fasten with zip ties to a wire bundle or any part behind the dash that will secure the device.
Test Camera Functionality
STEP ONE
Start the truck's engine.
STEP TWO
Make sure that the camera has power
(indicated by the solid red LED on the left and
may take 30-45 seconds to receive power).
Other LED Indictors:
GPS - Green (middle) - once connected to POV,
the GPS be pulled from the ELD. Drivers will
not see this light.
GSM - Blue
PedigreeTechnologies.com | Support: (701)-499-0022
Unused
5
To Accessory Cable
To Power Bank
Red Power LED
CameraView
JC400
Advertisement
