Advertisement
Installation Steps, Continued
Dry Fit
Determine proper placement of camera on the
front windshield. (Dry fit only. It's important to run
cabling to power source and determine where it will
fit properly.)
• High on the windshield next to the rearview mirror
area or just left or right of center divider
• Highest possible placement within the wiper
blade path
• Avoid any overhanging exterior sun visor or other
materials on glass including rock chips or cracks.
Installation Steps, Continued
Power Cable
During the dry fit, make sure you can route the cable inside the headliner and A pillar to the power
box. (Avoid airbags and other hardware inside the A pillar.) Cables and wiring should not be visible
after installation is complete. (Connect the accessory harness to power/fuse panel before actually
routing the cables in the A pillar.)
PedigreeTechnologies.com | Support: (701)-499-0022
3
CameraView
JC400
Advertisement
