12.4 Mounting
The control has been foreseen for wall mounting. For mounting purposes, 4 mounting holes for screws
with a max. diameter of ∅6mm must be available. For installing, please open the cover and screw the
control to the wall or to the mounting plate tightly with the four screws
180mm
280mm
380mm
d = 7 mm max.
180 mm.
HOMA Pump Technology
(Dimension of the mounting holes for
the control units up to 200 x 400mm, see
diagram on the left). After installation,
carry out the required electrical wiring.
Close the cover and screw tight.
Attention: In order to comply to the Degree of
Protection IP54, the enclosure cover must be
closed tight! Not used cable gland holes have
to be replaced by a screw cap.
HSK_operating_manual_English_Ver3.doc
-
-
38