Messages After Starting The System - Homa HSK15 Operating Manual

•
communication
•
alarms
•
system indications
By pressing the OK-key the relevant submenus (system menus) can be accessed. Here, specific
values can be viewed and/ or changed.
By means of the arrow keys (
the menu point "back to main menu" the main menu is displayed again.
By pressing the OK key in all other menu points, the input mode of the respective menu point is
accessed. The input mode is marked by a ↵-sign, in the LCD Display on the lower right hand side.
By means of arrow keys (
be changed. If entering a multi-digit number is required, the highest digit is changed first. With the OK
key the next digit position is selected etc.
If a value needs to be changed, the OK key must be pressed first.
Before carrying out settings for the first time, however, a password must be entered. If, the OK key is
pressed in a menu point for the first time, entering a password is requested:
Password:
Using the arrow keys (
key, the next position up to the fourth position can be selected. If the valid password has been
entered, in future, the adjustment values can be directly changed. The factory default password is
0000. If the wrong password has been entered, the message "false password" appears. Prompting of
the password appears until the correct password has finally been entered. Once the correct password
has been entered and confirmed by pressing the OK key, all setting values can be changed and the
controller can be configured.
Should a key not be pressed for approx. 5 minutes, the control returns to the main display and the
validity of the password expires. The password must be entered again.
5.5

Messages after starting the system

When the HSK is switched on, self checking of the program memory is conducted. A message
"Checking ROM" is displayed. In case of a fault, the control unit is stopped and the fault message
"contact service" is indicated. In case of this message, the CPS unit is not operable and for security
reasons will not start.
When self checking is successful, a message is briefly displayed, for example:
Mode: 03EE
Modem: 0
HSK_operating_manual_English_Ver3.doc
) scrolling from menu to menu is possible. By pressing the OK key in
), the values can be selected and by pressing the OK key the values can
), a respective position within the password can be changed. Using the OK
HOMA Pump Technology - -
13