Language Selection; Changing Password; Number Of Pumps; Time Delay Start - Homa HSK15 Operating Manual

6.5.1

Language selection

In this menu, the language to be used can be selected. Selection is effected by the
selected language is confirmed with the OK-key. All text messages appear in the selected language.
6.5.2 Changing passwords
In this menu the password of the controller can be changed
the new password (4-digit number) is entered and the new password is confirmed once again in the
second line. When both numbers match, then the new password is valid. The password should be
noted and kept in a safe place otherwise, access to the system menu of the controller is not possible
any more.
If the password is lost, then the controller must be re-
configured by the manufacturer. For security reasons,
changing of configurations without a password is not
possible.
6.5.3

Number of pumps

In this menu it can be determined, whether the control is to operate as a single or a dual pump control.
After pressing of the OK-key, the number of pumps (1, 2, 1/1) can be selected by means of
the - or -key. Following options are available:
1 one pump
1 / 1 alternating operation two pumps
2 peak load operation two pumps
Selection is confirm with the OK key.
6.5.4

Time delay start

After switching on the controller, the controller will not start immediately The controller is activated only
after the set delay time has elapsed. In case of a mains voltage loss or a phase sequence fault, the
controller is activated only after the set time period. The delay time period is adjusted in seconds.
Entering a value of 0000 deactivates this function.
If a value of 1000 is entered, then the delay time period (between 0 and 59 seconds) is randomly
determined with each new start.
8
The factory default password is 0000
9
Only in case of a dual pump control HSK25; in case of a single pump control HSK15, this menu does
not appear.
9
HOMA Pump Technology
8
. After pressing the OK-key,
HSK_operating_manual_English_Ver3.doc
- or -key. The
- -
24