Bayside LAGOON Installation, Operation And Maintenance Manual page 8

Lagoon Fan Installation Instructions
• Loosen two screws (1) from the mounting bracket (5).
• Loosen two screws (2) by half thread from the mounting
bracket (5).
• Lift the hanging canopy (3) of the fan assembly up to
the mounting bracket and let the L-shape slot on the
hanging canopy go through the screws (2) on the
mounting bracket. Turn the hanging canopy until it locks
in place at the end section of the L-shape slot and
secure it by tightening the two screws (1). Avoid
damaging the electrical wiring prepared previously.
• Finally attach the canopy cover (4) to the mounting bracket, secure it by pushing the hooks
of the canopy cover into the slot holes of the hanging canopy and turn it anti clockwise.
REMOTE CONTROL
Your ceiling fan is controlled via the remote control. There are 4 buttons (HI, MED, LOW, OFF) to control
the fan speed and one button to control light on/off. Fig. 10
Before operating the remote, the following must be considered.
-
2 x AAA 1.5V (size) batteries are required to operate the remote control. Remove the battery cover
from the back of the remote and insert 2 x AAA batteries. Ensure the polarities are correct as
shown in the battery compartment. Fig. 8 (Batteries included.)
-
The remote (transmitter) and receiver must be configured so that communication between each
other is paired up. This is achieved by setting the DIP switch on the receiver and remote on the
same setting. Fig. 9
Note: The DIP switch assembly has 4 switches which can be setup to 16 different transmitting
code combinations. This is practical when there is more than 1 remote/receiver pair operating
locally or in the same room.
Note: To access the receiver DIP switches, remove the DIP switch cover.
Fig. 8 Remote battery compartment
7 | P a g e
FINISHING THE INSTALLATION
USING YOUR CEILING FAN
Fig. 7
Fig. 9 Receiver DIP switch
V1.1-EU (10/2020)