Bayside LAGOON Installation, Operation And Maintenance Manual page 7

Lagoon Fan Installation Instructions
Complete the electrical wiring using the diagram below (Fig.6).
•
Complete the electrical wiring according to the 'ELECTRICAL WIRING DIAGRAM' section below.
PREPARE AND COMPLETE THE ELECTRICAL WIRING --- WIRING DIAGRAM (FIG. 6)
WARNING: FOR YOUR SAFETY ALL ELECTRICAL CONNECTIONS MUST BE UNDERTAKEN BY A
LICENSED ELECTRICIAN.
NOTE: AN ADDITIONAL ALL POLE DISCONNECTION SWITCH MUST BE INCLUDED IN THE FIXED
WIRING.
From mains supply to mounting bracket terminal block: (Fig. 6)
Connect the live supply wire to the "L" terminal of the terminal block on the mounting bracket.
1.
Connect the neutral supply wire to "N" terminal of the terminal block on the mounting bracket.
2.
3. Connect earth wire to the earth terminal of the terminal block on the mounting bracket.
From mounting bracket to receiver and motor: (Fig. 6)
4. Connect the supply wiring connector from the mounting bracket to the input of the remote receiver.
5. Connect the output wires connector of remote receiver to the input wires connectors of the fan motor
and the light kit.
6 | P a g e
Fig. 6
V1.1-EU (10/2020)