Bayside LAGOON Installation, Operation And Maintenance Manual page 11

Lagoon Fan Installation Instructions
WOBBLE:
NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet. If the
fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimetres is quite
acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket and down rod are
secure.
BALANCING KIT: A balancing kit is provided to balance the ceiling fan on initial installation. Please refer to the
instruction on how to use the balancing kit. The balancing kit can be used to assist re-balancing should the ceiling
fan become un-balanced again. Store your balancing kit away after installation for future use if required.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and frequency
signals superimposed in the electricity for off-peak hot water control, may cause a change in fan motor noise. This
is normal. Please allow a 24-hour "settling-in" period, most noises associated with a new fan disappear during this
time.
The manufacturer's warranty covers actual faults that may develop and NOT minor complaints such as hearing the
motor run – All electric motors are audible to some extent.
CARE AND CLEANING:
•
Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free cloth to avoid
scratching the paint finish. Please turn off electricity power when you do so.
•
Do not immerse your ceiling fan in the water. It could damage the motor or the blades and create the possibility
of an electrical shock.
•
Ensure that the fitting does not come in contact with any organic solvents or cleaners.
•
To clean the fan blade, wipe with only a damp clean cloth with NO organic solvents or cleaners.
•
The motor has a permanently lubricated ball bearing so there is no need to oil.
NOTE: Always turn OFF the power at the mains switch before attempting to clean your fan.
Fan models
Lagoon CTC/
SKU#213034;213035
Lagoon CTC/
SKU#213036;213037
IN EUROPE – If you are a European customer please contact the retail outlet where the fan was
purchased for warranty service.
10 | P a g e
AFTER INSTALLATION
TECHNICAL INFORMATION
Rated Voltage Rated power (motor)
220-240 V~
220-240 V~
WARRANTY INFORMATION
Rated power lamp
55 W N/A
GX53,18W,
55 W
3000K, 3 step-dim
1700lm,
V1.1-EU (10/2020)