Table of Contents
Advertisement
SERVICE MANUAL
. External views
6
Door
Handle
Control panel
Chapter 3 Installation, adjustments
and maintenance
●
3-1. Unpacking
1. Remove all packaging material; this includes the foam base and all adhesive tape holding the
freezer
●
accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before powering on the
freezer.
●
3-2. Adjusting
1. The freezer is designed for freestanding installation
only. It should not be recessed or built-in.
●
2. Place the freezer on a floor strong enough to support it fully loaded.
3. When moving freezer, never
tilt it more than a 45-degree angle. This could damage the compressor
●
and the sealed system.
4. If freezer is tilted let it stand in an upright position for at least 24 hours prior to plugging. This is to allow
the refrigerant to settle.
5.Proper Air Circulation
To assure the freezer works at the maximum efficiency it was designed for, you should install it in a
location where there is proper air circulation, Plumbing and electrical connections.
The following are recommended clearances around the freezer:
6
Advertisement
Table of Contents
